When you install a chimney flashing system there are many different ways to flash a chimney. Chimneys are the most common source of leaks in residential roofing industrije.Dimnjaka leakage areas are usually caused by many things, one way is the ponding of water in the area behind the stacks, which is prone to severe leaks due to non-movement of the water aspect. Flashing leaks, which were at the seams on the uptake by the leakage concerns as well. And at the end of the ice dam, when the snow and ice stuck behind the chimney, it may leak.
One way to chimneys without leaks is to install a chimney cricket. Chimney crickets make very good sense, they divert the water, and crickets to keep the water flowing around the chimney, instead of water flowing through the chimney, causing major water damage. Install a chimney crickets can reduce ponding issues, reducing ponding of water behind the chimney itself. They reduce the LED back-up, crickets keep ice from building up behind the chimney. They also draw water from the joints, properly installed chimney crickets to keep any water flowing away from the chimney seam.
Chimney crickets are required on all roofs steeper than 6 / 12 to handle the volume of water on the roof. For all the chimneys, which are wider than 24 "to reduce the ponding of water problems. And in all the chimneys in the north due to ice dams, snow loads, and the cycle of freezing and thawing. Making chimney crickets can be somewhat tedious task. They are manufactured from either wood or metal. tree crickets easy to produce, are available on site, complete with shingles to match the roof. cicadas metals were measured using non-corrosive metal that is required. they are consistent with a lower roof pitch, do not require additional work and are also easy to install.
Cricket sizes vary depending on the size of the roof work. They can range from 6 "to stack back to a minimum, to handle the volume of water droplets and exposure. They can also extend 12" up to the roof surface to create a broad enough water diverter.
Another way to flash a chimney is to use the substrate uptake system. Install shingles colleagues or roof deck armor protection around the chimney, through the tree crickets. Do not run the shingle-mate or deck armor up the chimney, so the leak can be barrier sealed to the chimney. Install weather storm watch or guard leak barrier over the shingles or roof-mate shell surface to waterproof the area. Seal the chimney by a minimum of 5 "to completely seal the walls of any infiltration of water. It protects the form of any movement or settling, chimneys and roof deck to move independently, so it makes sense because a leak barrier to adhere to in order to split or crack with structural movement.
0 komentar:
Posting Komentar